Avaya S8700 Series, Руководство по обслуживанию

Страница: 917 / 2618

ATM-EI (Expansion Interface Circuit Pack)
Issue 1 May 2002 8-195 555-233-143
Table 8-81. ATM Error Types 1024 - 1151
Error Type Description General problem
1024 Next node unreachable ATM protocol stack on ATM-EI
circuit pack
1056 DTL Transit not my node ID
1088 or
1104 ATM-EI circuit pack received a request with an
invalid connection identifier. Firmware-detected problems on the
ATM-EI circuit pack. Note: Error
Types 1088–1103 are reported by
the board that is originating the
connection. Error Types
1104–1119 are reported by the
board that is terminating the
connection. In most cases, when
the terminating board reports one of
these errors, the originating board
also reports an ATM-NTWK error
for the same event (usually with
Error Type 21).
1089 or
1105 ATM-EI circuit pack received a request with a
reference to an unknown VC token.
1090 or
1106 ATM-EI circuit pack did not have enough
resources (memory) for the requested operation.
1091 or
1107 Internal failure in the local protocol stack. This
can occur when the connection to the ATM switch
failed, perhaps because the:
■
ATM switch rebooted
■
fiber between the ATM switch and the
ATM-EI circuit pack disconnected
1092 or
1108 ATM-EI circuit pack received a request for which
the referenced VC was in the wrong call state.
1093 or
1109 ATM-EI circuit pack received a request for which
the VPI/VCI pair was invalid or out of range.
1094 or
1110 ATM-EI circuit pack received a request to add a
party to an existing VC. The add party request
failed, and a retry was not possible.
1095 or
1111 ATM-EI circuit pack in link recovery after the
lower ATM layer (Q.SAAL portion of the protocol
stack) failed. This can occur when the connection
to the ATM switch failed, perhaps because the:
■
ATM switch rebooted
■
fiber between the ATM switch and the
ATM-EI circuit pack disconnected
1096 or
1112 ATM-EI circuit pack received an error from the
local protocol stack for which no more detailed
cause was specified.
1102 ATM-EI circuit pack asked to create more
connections that it was capable of creating.
1103 ATM-EI circuit pack detected an illegal message
from software.
Check the Error Log for CONN-M proc errors for
more information.
1113 Problems detected by the board
terminating the connection