Avaya S8700 Series, Руководство по обслуживанию

Страница: 222 / 2618

Additional Maintenance Procedures
555-233-143 5-36 Issue 1 May 2002
Normally you should invoke only the full or supervision tests. The other options
are provided mainly for use in setting up an ATMS schedule. The tests that are
run depend on the type of TTL at the far end to which the test call is made. The
following table shows which tests are run for each type of TTL. The command
syntax is as follows:
test analog-testcal
trunkgroup#/| member#| port UUCSSpp | boardUUCSS
[full | supervision | no-selftest | no-return-loss | no-st-or-rl]
[repeat#][schedule]
Input Parameters
Different TTLs have different measurement capabilities and you will need the
following information about specific TTL types. This table does not include the
self-test nor does it distinguish between measurements for different test tone
levels.
trunk addresses You can specify a single trunk or several trunks by using trunk, port,
or board addresses. These parameters are described in the
introduction to
‘‘Common Input Parameters’’ on page 7-6 . If you
enter a trunk-group number without a member number, every
member of the group is tested.
full This executes the most comprehensive test call available using the
administered test set type.
“Full“ is the default.
supervision This test takes about 10 seconds and simply confirms the presence
of testing capability at the far end.
no-selftest This executes the full test, but skips self test sequences. This saves
about 20 seconds on the type 105 transmission test and has no effect
on type 100 and 102 transmission tests.
no-return-loss This executes the full test but skips return loss sequences. This
saves about 20 seconds on the type 105 transmission test and has
no effect on type 100 or 102 transmission tests.
no-st-or-rl This executes the full test but skips the self test and the return loss
sequences. This saves about 40 seconds on the type 105
transmission test and has no effect on type 100 or 102 transmission
tests.
repeat # This specifies repeating the tests up to 99 times. The default is a
single run of the tests.
schedule This qualifier brings up a form for scheduling execution of the test at a
later time. This is not the same as setting up an ATMS test schedule
described in
‘‘Running ATMS Tests (Test Analog-Testcall
Command)’’ on page 5-35 .