Avaya S8700 Series, Руководство по обслуживанию

Страница: 2463 / 2618

UDS1-BD (UDS1 Interface Circuit Pack)
Issue 1 May 2002 8-1741 555-233-143
120A1 CSU Module/Sync Splitter
This test is also used to maintain the 120A1 CSU module or the 401A T1 sync
splitter, and the 402A or 403A E1 synchronization splitter. The CSU module,
when combined with the functionality provided by the UDS1 circuit pack, provides
functionality equivalent to an external stand-alone ESF T1 CSU. The combination
of the UDS1 and 120A1 CSU module is known as an Enhanced Integrated CSU
(I-CSU).
The 401A T1 synchronization splitter, when combined with the functionality
provided by the UDS1 circuit pack, allows an ATM switch to derive its timing from
a T1 connected to the UDS1 in the S8700 Multi-Connect.
The 402A or 403A E1 synchronization splitter, when combined with the
functionality provided by the UDS1 circuit pack, allows an ATM switch to derive its
timing from an E1 connected to the UDS1 in the S8700 Multi-Connect.
If a UDS1 circuit pack detects certain I-CSU/Sync Splitter hardware errors, it
notifies maintenance. When the maintenance subsystem receives notification of
the I-CSU/Sync Splitter error, it executes this Loss of Signal Alarm Inquiry test
(#138). The test, in addition to querying for a Loss of Signal alarm condition, also
queries the UDS1 board to confirm the I-CSU/Sync Splitter error. A Minor or
Warning alarm is raised depending on the severity of the I-CSU/Sync Splitter
error. The trunks on the board may be taken out of service if the I-CSU/Sync
Splitter error is deemed serious.
If a Loss Of Signal alarm and an I-CSU/Sync Splitter error co-exist, the Loss Of
Signal alarm condition takes priority, and the board and all of its trunks are put in
the out-of-service state. However, errors are logged for both.
When the maintenance subsystem receives notification that the I-CSU/Sync
Splitter hardware error condition no longer exists, maintenance will restore the
board and its trunks to their previous service state, if the alarm can be cleared (no
other I-CSU/Sync Splitter errors or Loss Of Signal alarms exist).
Echo Cancellation
If the TN464GP/TN2464BP or later suffix UDS1 firmware detects a serious echo
canceller hardware error, it notifies maintenance software. When the
maintenance subsystem receives notification of the echo cancellation error, it
executes this Loss Of Signal Alarm Inquiry test.
This test, in addition to querying for a loss-of-signal condition and ICSU errors,
also queries the TN464GP/TN2464BP to confirm the echo canceller error. A
minor alarm is raised if the error is confirmed. The board’s trunks remain
in-service since the board is still functional except for its echo-cancellation
capability.