Avaya S8700 Series, Руководство по обслуживанию

Страница: 762 / 2618

Maintenance-Object Repair Procedures
555-233-143 8-40 Issue 1 May 2002
Loop-Around Test (#161)
This test is designed to check the on-board transmission capabilities of the NPE
on the analog port.
Table 8-15. Test #161 Loop-Around Test
Error
Code Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources for this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use the display port UUCSSpp command to determine the station
extension. Use the status station command to determine the service
state of the port. If the port is active, wait until it is idle before testing.
2. If the port status is idle, retry the command at 1-minute intervals up to 5
times.
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present, or some Tone Detectors
may be out of service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals up to 5
times.
1004 ABORT The port was seized by a valid call during the test. The test has been aborted.
1. Use the display port UUCSSpp command to determine the station
extension. Use the status station command to determine the service
state of the port. If the port is active, wait until it is idle before testing.
2. Retry the command at 1-minute intervals up to 5 times.
1018 ABORT Test disabled by administration. To enable the test for the particular analog
station, enter the change station extension command and change the “Test?”
field on the Station Form from “n” to “y.”
2000 ABORT Response to the test was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Continued on next page