Avaya S8700 Series, Руководство по обслуживанию

Страница: 2506 / 2618

Maintenance-Object Repair Procedures
555-233-143 8-1784 Issue 1 May 2002
1015 ABORT Ports on the UDS1 Interface circuit pack have not been busied out to
out-of-service.
1. Enter the busyout board UUCSS command to put every trunk or port of
the UDS1 Interface circuit pack into the out-of-service state.
2. Retry the command.
1039 ABORT The UDS1 Interface circuit pack is providing timing for the system. Executing
this test could cause major system disruption.
If the UDS1 Interface circuit pack needs to be tested, set the synchronization
reference to another DS1 Interface circuit pack or to the IPSI or Tone-Clock
circuit pack via the following command sequence:
1. Issue the disable synchronization-switch command.
2. Next, issue the set synchronization UUCSS command.
3. Lastly, issue the enable synchronization-switch command.
1950 ABORT Another loopback/span test is already executing on the DS1 board or the board
is in a network-requested loop-back mode (line loopback or payload loopback).
The hardware error log will indicate whether a Customer Loop-Back Jack test,
Far CSU Loopback test, or the One-Way Span test is executing or if the board
is in line-loopback or payload-loop-back mode. Only one long-duration
loopback/span tests can be active at a given time. Thus, if a loopback/span
test is already active, that test must be terminated using the test ds1-loop
UUCSS end-loopback/span-test command in order to execute this test.
1951 ABORT The CSU Repeater Loopback test could not be executed because the 120A1
CSU module or the 401A T1 sync splitter was not physically installed.
Physically connect the 120A1 CSU module or the 401A T1 sync splitter to the
UDS1 board behind the port carrier.
Table 8-684. Test #1211 CSU Repeater Loop-Back Test — Continued
Error
Code Test
Result
Description / Recommendation
Continued on next page