Avaya S8700 Series, Руководство по обслуживанию

Страница: 1899 / 2618

M/T-PKT (Maintenance/Test Packet Bus Port)
Issue 1 May 2002 8-1177 555-233-143
If the system has been in a stable state for more than 15 minutes, try the
following procedure:
1. Reset the Maintenance/Test circuit pack from the G3-MT as follows:
■
Enter the busyout board UUCSS command.
■
Enter the reset board UUCSS command.
■
Enter the release board UUCSS command.
2. Wait 15 minutes.
3. If the error recurs, replace the Maintenance/Test circuit pack.
When this alarm is active, the amber LED will be in one of three states:
■
An unlit amber LED indicates no activity on the Maintenance/Test
circuit pack. You can replace the Maintenance/Test circuit pack.
■
If there is an indication of an uncorrectable fault on the packet bus,
the amber LED will be blinking at a rate of 1 Hz. It is OK to replace
the Maintenance/Test circuit pack. Ignore the packet-bus error
indication, since the Maintenance/Test circuit pack has been
determined to be defective.
■
If there is other activity on the Maintenance/Test circuit pack (i.e.,
ISDN test call), or if there is an indication of a correctable fault on
the packet bus, the amber LED will be on steady. If there is an ISDN
test call in progress, it must be halted via the clear isdn-testcall
grp/member command prior to replacing the circuit pack. Ignore
the packet-bus error indication, since the Maintenance/Test circuit
pack has been determined to be defective.
d. This error indicates a failure of the Packet Bus Port Health Inquiry test.
Either the packet-bus port has reported a self-test failure, or the Avaya
MultiVantage™ software can communicate with the Maintenance/Test
circuit pack but not with the Maintenance/Test circuit pack packet-bus port.
Refer to the description of the Packet Bus Port Health Inquiry test, and
follow the instructions indicated for the failure code that matches the
Aux
Data
field.