Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.3.1.0
Introduced for the E-Series.
Usage
Information
This command disables the incrementing of the hops field when boot requests are
relayed to a DHCP server through the system. If the incoming boot request already
has a non-zero hops field, the message is relayed with the same value for hops.
However, the message is discarded if the hops field exceeds 16, to comply with the
relay agent behavior specified in RFC 1542.
Related
Commands
ip helper-address
— specifies the destination broadcast or host address for DHCP
server requests.
show running-config
— displays the current configuration and changes from the
default values.
ip host
Assign a name and IP address the host-to-IP address mapping table uses.
Z9500
Syntax
ip host name
ip-address
To remove an IP host, use the
no ip host name [
ip-address
]
command.
Parameters
name
Enter a text string to associate with one IP address.
948
IPv4 Routing
