ntp disable
Prevent an interface from receiving NTP packets.
Syntax
ntp disable
To re-enable NTP on an interface, use the
no ntp disable
command.
Defaults
Disabled (that is, if you configure an NTP host, all interfaces receive NTP packets)
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.1.1.0
Introduced on the E-Series.
ntp multicast client
To receive NTP information from the network via multicast, configure the switch.
Z9500
Syntax
ntp multicast client [
multicast-address
]
To disable multicast reception, use the
no ntp multicast client
[
multicast-address
]
command.
Parameters
multicast-
address
(OPTIONAL) Enter a multicast address. Enter either an IPv4
address in dotted decimal format or an IPv6 address in
X:X:X:X::X format. If you do not enter a multicast address, the
address:
System Time and Date
1793
