protocol-tunnel
Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
Z9500
Syntax
protocol-tunnel {rate-limit
rate
| stp}
To disable protocol tunneling for a Layer 2 protocol, use the
no protocol-
tunnel
command.
Parameters
rate-limit
rate
Enter the keyword
rate-limit
followed by a number for
the rate-limit for tunneled packets on the VMAN. The range
is from 64 to 320.
stp
Enter the keyword
stp
to enable protocol tunneling on a
spanning tree, including STP, MSTP, RSTP, and PVST.
Defaults
none
Command
Modes
CONF-IF-VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.11.1
Introduced on the Z9000.
8.5.1.1
Added support for
802.1X
,
E-LMI
,
GMRP
,
GVRP
,
LLDP
,
LACP
,
MMRP
,
MVRP
, and
OAM 802.3ah
protocol traffic to the E-
Series ExaScale.
8.2.1.0
Introduced on the C-Series, E-Series, and E-Series ExaScale.
7.4.1.0
Introduced
Example
Dell#conf
Dell(conf)#interface vlan 2
Dell(conf-if-vl-2)#vlan-stack compatible
Dell(conf-if-vl-2)#member Te 1/2-3
Dell(conf-if-vl-2)#protocol-tunnel stp
Dell(conf-if-vl-2)#protocol-tunnel enable
Related
Command
show protocol-tunnel
— displays tunneling information for all VLANs.
1686
Service Provider Bridging
