Dell Networking Z9500, Command Reference Manual

Page: 1182 / 1905

Version Description
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Related
Commands
protocol lldp (Configuration) — enables LLDP globally.
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
hello
Configure the rate at which the LLDP control packets are sent to its peer.
Z9500
Syntax
hello seconds
To revert to the default, use the
no hello seconds
command.
Parameters
seconds Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is from 5 to 180 seconds. The
default is
30 seconds .
Defaults 30 seconds
Command
Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
1182
Link Layer Discovery Protocol (LLDP)