garp timers
Set the intervals (in milliseconds) for sending GARP messages.
Z9500
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the
no garp timers {join | leave |
leave-all}
command.
Parameters
join
Enter the keyword
join
then the number of milliseconds to
configure the join time. The range is from 100 to 147483647
milliseconds. The default is
200 milliseconds
.
NOTE: Designate the milliseconds in multiples of 100.
leave
Enter the keyword
leave
then the number of milliseconds
to configure the leave time. The range is from 100 to
2147483647 milliseconds. The default is
600 milliseconds
.
NOTE: Designate the milliseconds in multiples of 100.
leave-all
Enter the keywords
leave-all
then the number of
milliseconds to configure the leave-all time. The range is
from 100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Defaults
As above.
Command
Modes
CONFIGURATION-GVRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on C-Series, E-Series, and S-Series
796
GARP VLAN Registration (GVRP)
