• IP protocol number: from 0 to 255
• Internet control message protocol (
icmp
) but not the ICMP message type (from
0 to 255)
• Any internet protocol (
ip
)
• Transmission Control Protocol (
tcp
) but not on the
rst
,
syn
, or
urg
bits
• User Datagram Protocol (
udp
)
In the case of ambiguous access control list rules, the
debug ip packet
access-control
command is disabled. A message appears identifying the error
(refer to the Example below).
Example (Error
Messages)
Dell#debug ip packet access-group test
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
Dell#00:10:45: %RPM0-P:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is
turned off
Dell#
ip address
Assign a primary and secondary IP address to the interface.
Z9500
Syntax
ip address {
ip-address mask
[secondary] | dhcp}
To delete an IP address from an interface, use the
no ip address [
ip-
address
]
command.
Parameters
ip-address
Enter an IP address in dotted decimal format.
mask
Enter the mask of the IP address in slash prefix format (for
example, /24).
secondary
(OPTIONAL) Enter the keyword
secondary
to designate the
IP address as the secondary address.
dhcp
Enter the keyword
dhcp
to configure an interface to receive
its IP address from the configured DHCP server.
Defaults
Not configured.
IPv4 Routing
941
