Command
Modes
CONFIGURATION-UDF TCAM
Example
Dell(conf-udf-tcam)#match l2ethertype ipv4 ipprotocol 4
vlantag any
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.8(0.0)
Introduced on the S6000, Z9500.
Related
Commands
udf-tcam
— creates a context for UDF TCAM.
show config
— displays the current UDF TCAM profile configuration.
permit ip
Associate the UDF in IP access-list.
Syntax
permit ip {
source mask
| any | host
ip-address
} {
destination
mask
| any | host
ip-address
} udf-pkt-format
name
udf-
qualifier-value
name
To remove this filter, use the
no seq
sequence-number
command.
Parameters
source
Enter the IP address of the network or host from which the
packets were sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or noncontiguous.
any
Enter the keyword
any
to specify that all routes are subject
to the filter.
host
ip-address
Enter the keyword
host
then the IP address to specify a host
IP address.
destination
Enter the IP address of the network or host to which the
packets are sent.
udf-pkt-format
name
Enter the keywords
udf-pkt-format
then the UDF ACL
profile name.
udf-qualifier-
value
name
Enter the keywords
udf-qualifier-value
then the UDF
qualifier value profile name.
340
Access Control Lists (ACL)
