Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.4.2.3
Introduced on the S-Series S50.
Usage
Information
After you enter the command, to assign upstream and downstream interfaces to
the group, enter Uplink-State-Group Configuration mode.
An uplink-state group is considered to be operationally up if at least one upstream
interface in the group is in the Link-Up state.
An uplink-state group is considered to be operationally down if no upstream
interfaces in the group are in the Link-Up state. No uplink-state tracking is
performed when a group is disabled or in an operationally down state.
To disable upstream-link tracking without deleting the uplink-state group, use the
no enable
command in uplink-state-group configuration mode.
Example
Dell(conf)#uplink-state-group 16
Dell(conf-uplink-state-group-16)#Dec 3 00:46:45: %SYSTEM:CP
%IFMGR-5-ASTATE_UP: Changed uplink state group
Admin state to up: Group 16
Related
Commands
•
show running-config uplink-state-group
— displays the current configuration
of one or more uplink-state groups.
•
show uplink-state-group
— displays the status information on a specified
uplink-state group or all groups.
upstream
Assign a port or port-channel to the uplink-state group as an upstream interface.
Z9500
Syntax
upstream
interface
To delete an uplink-state group, use the
no upstream interface
command.
Parameters
interface
Enter one of the following interface types:
• 10-Gigabit Ethernet:
tengigabitethernet {
slot/
port
|
slot/port-range
}
Uplink Failure Detection (UFD)
1823
