Version
Description
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
7.6.1.0
Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
7.5.1.0
Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
E-Series legacy
command.
ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
Z9500
Syntax
ip igmp query-interval
seconds
To return to the default values, use the
no ip igmp query-interval
command.
Parameters
seconds
Enter the number of seconds between queries sent out. The
range is from 1 to 18000. The default is
60 seconds
.
Defaults
60 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Maximum range of the Hello interval value is changed to
18000. Introduced on the S6000-ON.
9.5(0.0)
Introduced on the Z9500.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0
Introduced on the S6000.
812
Internet Group Management Protocol (IGMP)
