metric-value
Enter a number as the new metric value. The range is from
zero (0) to 4294967295.
Defaults
Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.1.1.0
Introduced on the E-Series.
Related
Commands
set automatic-tag
— computes the tag value of the route.
set level
— specifies the OSPF area for route redistribution.
set metric-type
— specifies the route type assigned to redistributed routes.
set tag
— specifies the tag assigned to redistributed routes.
set metric-type
To assign a new route type for routes redistributed to OSPF, configure a filter.
Z9500
Syntax
set metric-type {internal | external | type-1 | type-2}
To delete a setting, use the
no set metric-type
command.
Parameters
internal
Enter the keyword
internal
to assign the Interior Gateway
Protocol metric of the next hop as the route’s BGP
MULTI_EXIT_DES (MED) value.
external
Enter the keyword
external
to assign the IS-IS external
metric.
326
Access Control Lists (ACL)
