at a specific privilege level. If no privilege level is specified, the default is privilege
level
15
.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do
not need to enter an enable password.
Related
Commands
enable password
— configures a password for the
enable
command and to
access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Z9500
Syntax
enable optical-info-update interval
seconds
To disable optical power information updates, use the
no enable optical-
info-update interval
command.
Parameters
interval
seconds
Enter the keyword
interval
then the polling interval in
seconds. The range is from 120 to 6000 seconds. The
default is
300 seconds
(5 minutes).
Defaults
Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Replacement command for the S4820T. Replaces the
enable xfp-power-updates
command.
8.3.11.4
Replacement command for the Z9000. Replaces the
enable xfp-power-updates
command
8.3.10.0
Replacement command for the S4810 only. Replaces the
enable xfp-power-updates
command.
Usage
Information
To enable polling and to configure the polling frequency, use this command.
Control and Monitoring
105
