ipv6 address eui64
Configure IPv6 EUI64 address configuration on the interface.
Z9500
Syntax
ipv6 address {
ipv6-address prefix-length
} eui64
To disable IPv6 EUI64 address autoconfiguration, use the
no ipv6 address
{
ipv6-address prefix-length
} eui64
command.
Parameters
ipv6-address
prefix-length
Enter the IPv6 prefix in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
9.2(0.0)
Introduced.
Usage
Information
This command allows you to create an EUI64 address based on the specified prefix
and MAC address only. Prefixes may be configured on the interface using the
ipv6
nd prefix
command without creating an EUI64 address.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
IPv6 Basics
1017
