set comm-list delete
To remove the specified community list from the BGP route’s COMMUNITY attribute, configure a filter.
Z9500
Syntax
set comm-list
community-list-name
delete
To insert the community list into the COMMUNITY attribute, use the
no set
comm-list
community-list-name
delete
command.
Parameters
community-
list-name
Enter the name of an established Community list, up to 140
characters.
Defaults
Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.8.1.0
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.1.1.0
Introduced on the E-Series.
Usage
Information
The community list used in the
set comm-list delete
command must be
configured so that each filter contains only one community. For example, the filter
deny 100:12
is acceptable, but the filter
deny 120:13 140:33
results in an
error.
If the
set comm-list delete
command and the
set community
command
are configured in the same route map sequence, the deletion command (
set
comm-list delete
) is processed before the insertion command (
set
community
).
Access Control Lists (ACL)
321
