ip pim rp-address
Configure a static PIM rendezvous point (RP) address for a group or access-list.
Z9500
Syntax
ip pim [vrf
vrf-name
] rp-address
address
{group-address
group-
address mask
} [override]
To remove an RP address, use the
no ip pim [vrf
vrf-name
] rp-address
address
{group-address
group-address mask
} [override]
command.
Parameters
vrf
vrf-name
(OPTIONAL) Enter the keyword
vrf
followed by the name of
the VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
address
Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address
mask
Enter the keywords
group-address
then a group-address
mask, in dotted decimal format (/xx), to assign that group
address to the RP.
override
Enter the keyword
override
to override the BSR updates
with static RP. The override takes effect immediately during
enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Added support for VRF. Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
1384
PIM-Sparse Mode (PIM-SM)
