To disable sending a COMMUNITY attribute, use the
no neighbor {
ipv6-
address
|
peer-group-name
} send-community
command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group to send a COMMUNITY
attribute to all routers within the peer group.
Defaults
Not configured and COMMUNITY attributes are not sent to neighbors.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.2.1.0
Introduced on the E-Series ExaScale.
7.4.1.0
Introduced
neighbor soft-reconfiguration inbound
Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
Z9500
Syntax
neighbor {
ipv4-address
|
ipv6-address
|
peer-group-name
} soft-
reconfiguration inbound
Parameters
ipv4-address
|
ipv6-address
Enter the IP address of the neighbor for which you want to
start storing inbound routing updates.
peer-group-
name
Enter the name of the peer group for which you want to start
storing inbound routing updates.
Defaults
Disabled.
Command
Modes
ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
552
Border Gateway Protocol
