Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.11.1
Introduced on the S55, S60, and S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.5.1.0
Introduced on the C-Series.
6.4.1.0
Introduced
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (
no shutdown
). To assign an IP
address to the Management port, use the
ip address
command.
If your system has two RPMs installed, use the
show redundancy
command to
display which RPM is the Primary RPM.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related
Commands
management route
— configures a static route that points to the Management
interface or a forwarding router.
duplex (Management)
— clears the forwarding information base (FIB) entries on a
specified line card.
speed (Management interface)
— clears the FIB entries on a specified line card.
interface null
Configure a Null interface on the switch.
Z9500
Syntax
interface null
number
Parameters
number
Enter zero (0) as the Null interface number.
Defaults
Not configured; number =
0
Interfaces
845
