Version
Description
9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
7.6.1.0
Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
7.5.1.0
Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
ip igmp ssm-map
To translate (*,G) memberships to (S,G) memberships, use a statically configured list.
Z9500
Syntax
ip igmp [vrf
vrf-name
] ssm-map
std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them
with (*,G) state, use the
ip igmp [vrf
vrf-name
] ssm-map
std-access-
list source-address
command.
Parameters
vrf
vrf-name
(OPTIONAL) Enter the keyword
vrf
followed by the name of
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
std-access-list
Specify the standard IP access list that contains the mapping
rules for multicast groups.
source-address
Specify the multicast source address to which the groups are
mapped.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
814
Internet Group Management Protocol (IGMP)
