Version
Description
7.7.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
Usage
Information
Advertise the Extended Power via MDI on all ports that are connected to an 802.3af
powered, LLDP-MED endpoint device.
Related
Commands
debug lldp interface
— debugs LLDP.
show lldp neighbors
— displays the LLDP neighbors.
show running-config lldp
— displays the LLDP running configuration.
advertise med softphone-voice
To advertise softphone to enable IP telephony on a computer so that the computer can be used as a
phone, configure the system.
Z9500
Syntax
advertise med softphone-voice {
vlan-id layer2_priority
DSCP_value
} | {priority-tagged
number
}
To return to the default, use the
no advertise med softphone-voice
{
vlan-id layer2_priority DSCP_value
} | {priority-tagged
number
}
command.
Parameters
vlan-id
Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority
Enter the Layer 2 priority (C-Series and E-Series only). The
range is from 0 to 7.
DSCP_value
Enter the DSCP value (C-Series and E-Series only). The range
is from 0 to 63.
priority-tagged
number
Enter the keywords
priority-tagged
then the Layer 2
priority. The range is from 0 to 7.
Defaults
unconfigured.
Command
Modes
CONFIGURATION (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
1194
Link Layer Discovery Protocol (LLDP)
