Version
Description
7.7.1.0
Introduced on the C-Series.
Usage
Information
CAUTION: Dell Networking recommends not changing the administrative
distance of internal routes. Changing the administrative distances may cause
routing table inconsistencies.
The higher the administrative distance assigned to a route means that your
confidence in that route is low. Routes assigned an administrative distance of 255
are not installed in the routing table. Routes from confederations are treated as
internal BGP routes.
Related
Commands
router bgp
— enters ROUTER mode on the switch.
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
Z9500
Syntax
show ip bgp [vrf
vrf-name
] [ipv4 {
multicast
|
unicast
} | ipv6
unicast
] dampened-paths
Parameters
vrf
vrf-name
(OPTIONAL) Enter the keywords
vrf
and then the name of
the VRF to view routes that are affected by a specific
community list corresponding to that VRF.
ipv4
unicast
(OPTIONAL) Enter the keywords
ipv4
followed by the
keyword
unicast
to view information related only to ipv4
unicast routes.
ipv6 unicast
(OPTIONAL) Enter the keyword
ipv6
followed by the
keyword
unicast
to view information related only to ipv6
unicast routes.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Added the ipv4 multicast and ipv6 unicast parameters.
Border Gateway Protocol
489