DCBX Commands
advertise dcbx-tlv
On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-
reco | pfc] [ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the
no advertise dcbx-tlv
command.
Parameters
{ets-conf | ets-
reco | pfc}
Enter the PFC and ETS TLVs advertised, where:
•
ets-conf:
enables the advertisement of ETS
configuration TLVs.
•
ets-reco:
enables the advertisement of ETS
recommend TLVs.
•
pfc:
enables the advertisement of PFC TLVs.
Defaults
All PFC and ETS TLVs are advertised.
Command
Modes
PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the Z9500.
Usage
Information
You can configure the transmission of more than one TLV type at a time; for
example:
advertise dcbx-tlv ets-conf ets-reco
.
You can enable ETS recommend TLVs (
ets-reco
) only if you enable ETS
configuration TLVs (
ets-conf
). To disable TLV transmission, use the
no
form of
the command; for example,
no advertise dcbx-tlv pfc ets-reco
.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the
show interface
dcbx detail
command.
Data Center Bridging (DCB)
617
