To remove the iSCSI session aging time, use the
no iscsi aging time
command.
Parameters
time
Enter the aging time for the iSCSI session. The range is from
5 to 43,200 minutes.
Defaults
10 minutes
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.6(0.0)
Introduced on the Z9500.
iscsi cos
Set the QoS policy that is applied to the iSCSI flows.
Syntax
iscsi cos {enable | disable | dot1p
vlan-priority-value
[remark] | dscp
dscp-value
[remark]}
To disable the QoS policy, use the
no iscsi cos
command.
Parameters
enable
Enter the keyword
enable
to allow the application of
preferential QoS treatment to iSCSI traffic so that the iSCSI
packets are scheduled in the switch with a dot1p priority 4
regardless of the VLAN priority tag in the packet. The default
is: the iSCSI packets are handled with dotp1 priority 4
without remark.
disable
Enter the keyword
disable
to disable the application of
preferential QoS treatment to iSCSI frames.
dot1p
vlan-
priority-value
Enter the dot1p value of the VLAN priority tag assigned to the
incoming packets in an iSCSI session. The range is from 0 to
7. The default is the dot1p value in ingress iSCSI frames is not
changed and is the same priority is used in iSCSI TLV
advertisements if you did not enter the
iscsi priority-
bits
command.
iSCSI Optimization
1047
