Dell Networking Z9500, Command Reference Manual

Page: 58 / 1905

PROTOCOL GVRP Mode
To enable and configure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For
more information, refer to
GARP VLAN Registration (GVRP) .
To enter PROTOCOL GVRP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
protocol gvrp
command. The prompt changes to include (config-gvrp).
You can return to CONFIGURATION mode by using the
exit
command.
RAPID SPANNING TREE (RSTP) Mode
To enable and configure RSTP, use RSTP mode. For more information, refer to Rapid Spanning Tree
Protocol (RSTP) .
To enter RSTP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
protocol spanning-tree rstp
command. The prompt changes to include (conf-rstp).
You can return to CONFIGURATION mode by using the
exit
command.
ROUTE-MAP Mode
To configure a route map, use ROUTE-MAP mode.
To enter ROUTE-MAP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the
route-map map-name [permit | deny] [ sequence-number ]
command. The prompt
changes to include (config-route-map).
You can return to CONFIGURATION mode by using the
exit
command.
ROUTER BGP Mode
To enable and configure Border Gateway Protocol (BGP), use ROUTER BGP mode. For more information,
refer to
Border Gateway Protocol IPv4 (BGPv4)
To enter ROUTER BGP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the
router bgp
command then enter the AS number. The prompt changes to include (conf-
router_bgp).
You can return to CONFIGURATION mode by using the
exit
command.
ROUTER ISIS Mode
To enable and configure Intermediate System to Intermediate System (ISIS), use ROUTER ISIS mode. For
more information, refer to
Intermediate System to Intermediate System (IS-IS) .
To enter ROUTER ISIS mode:
58
CLI Basics