32
Multicast
The multicast commands are supported by Dell Networking operating system.
This chapter contains the following sections:
•
IPv4 Multicast Commands
•
IPv6 Multicast Commands
IPv4 Multicast Commands
This section describes the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent
multicast (PIM) tree information base, use the
clear ip pim tib
command.
Z9500
Syntax
clear ip mroute [vrf
vrf-name
] {
group-address
[
source-address
]
| * | snooping}
Parameters
vrf
vrf-name
(OPTIONAL) Enter the keyword
vrf
followed by the name of
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
group-address
[
source-
address
]
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
*
Enter * to clear all multicast routes.
snooping
Enter the keyword
snooping
to delete multicast snooping
route table entries.
Command
Modes
EXEC Privilege
Multicast
1205
