permanent
(OPTIONAL) Enter the keyword
permanent
to specify that
the route is not to be removed, even if the interface assigned
to that route goes down.
NOTE: If you disable the interface with an IPv6 address
associated with the keyword
permanent
, the route
disappears from the routing table.
weight
weight-
value
Enter the keyword
weight
followed by a weight value. The
range is from 0 to 255.
NOTE: Weight for a static route can be added only for
the destination address and not for the route pointing to
destination a interface.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Added support for VRF. Also included the
weight
parameter
to support weighted ECMP feature. Introduced on the
S6000-ON.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.5.1.0
Added support for 4-port 40G line cards on ExaScale.
8.2.1.0
Introduced on the E-Series ExaScale.
7.8.1.0
Introduced on the C-Series and S-Series.
7.4.1.0
Introduced on the E-Series TeraScale.
Usage
Information
When the interface goes down, Dell Networking OS withdraws the route. The route
is re-installed, by Dell Networking OS, when the interface comes back up. When a
recursive resolution is “broken,” Dell Networking OS withdraws the route. The route
is re-installed, by Dell Networking OS, when the recursive resolution is satisfied.
After an IPv6 static route interface is created, if an IP address is not assigned to a
peer interface, the peer must be manually pinged to resolve the neighbor
information.
1026
IPv6 Basics
