ipv6 control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
Z9500
Syntax
ipv6 control-plane egress-filter
Defaults
Not enabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.10.0
Introduced on the S4810.
permit (for IPv6 ACLs)
To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or
UDP.
Syntax
permit {
ipv6-protocol-number
| icmp | ipv6 | tcp | udp} [count
[byte]] [dscp
value
] [order] [fragments] [log [interval
minutes
] [threshold-in-msgs [
count
]] [monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command syntax if you know the filter’s
sequence number
• Use the
no permit {
ipv6-protocol-number
| icmp | ipv6 | tcp |
udp}
command
Parameters
log
(OPTIONAL) Enter the keyword
log
to enable the triggering
of ACL log messages.
threshold-in
msgs
count
(OPTIONAL) Enter the
threshold-in-msgs
keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
1002
IPv6 Access Control Lists (IPv6 ACLs)
