Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.1
Introduced on the S4810.
8.2.1.0
Introduced the hardware
shutdown-on-violation
option.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.5.1.0
Introduced on the E-Series.
Usage
Information
On an MSTP switch, a port configured as an edge port immediately transitions to
the Forwarding state. Only configure ports connected to end-hosts as edge ports.
Consider an edge port similar to a port with spanning-tree portfast enabled.
If you do not enable
shutdown-on-violation
, BPDUs are still sent to the RPM
CPU.
tc-flush-standard
Enable the MAC address flushing after receiving every topology change notification.
Z9500
Syntax
tc-flush-standard
To disable, use the
no tc-flush-standard
command.
Defaults
Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
1250
Multiple Spanning Tree Protocol (MSTP)
