• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination
Enter the IP address of the network or host to which the
packets are sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
count
(OPTIONAL) Enter the keyword
count
to count packets the
filter processes.
bytes
(OPTIONAL) Enter the keyword
byte
to count bytes the filter
processes.
order
(OPTIONAL) Enter the keyword
order
to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority) If you did not use the
keyword
order
, the ACLs have the lowest order by default
(255).
fragments
Enter the keyword
fragments
to use ACLs to control packet
fragments.
log
(OPTIONAL) Enter the keyword
log
to include ACL matches
in the log.
threshold-in
msgs
count
(OPTIONAL) Enter the
threshold-in-msgs
keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the
seq
,
permit
, or
deny
commands. The threshold range is from 1 to 100.
interval
minutes
(OPTIONAL) Enter the keyword
interval
followed by the
time period in minutes at which ACL logs must be generated.
The threshold range is from 1 to 10 minutes.
monitor
(OPTIONAL) Enter the keyword
monitor
when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the “Flow-based
Monitoring” section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide
.
Defaults
Not configured.
Command
Modes
CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
Access Control Lists (ACL)
241
