12
Debugging and Diagnostics
The debugging and diagnostics commands are supported on the Dell Networking OS platform.
This chapter contains the following sections:
•
Diagnostics and Monitoring Commands
•
Offline Diagnostic Commands
•
Buffer Tuning Commands
•
Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the
Control and Monitoring
chapter.
logging coredump
Enable a core dump.
Syntax
logging coredump {cp | linecard {
slot-number
|all} } rps}
Parameters
cp
Enter a core dump for the Control Processor.
linecard
Enter a core dump for a line card.
rps
Enter a core dump for Route Processor 1 or 2.
Defaults
The kernal core dump is enabled by default for the Route Processor (RP 1 and 2 on
the E-Series). The kernel core dump for the Control Processor and application core
dump are disabled on all systems by default.
Command
Modes
CONFIGURATION
Command
History
Version 9.7(0.0)
Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
646
Debugging and Diagnostics
