Parameters
remark-
number
Enter the remark number. The range is from 0 to 65535.
NOTE: You can use the same sequence number for the
remark and an ACL rule.
description
Enter a description of up to 80 characters.
Defaults
Not configured.
Command
Modes
• CONFIGURATION-IP ACCESS LIST-STANDARD
• CONFIGURATION-IP ACCESS LIST-EXTENDED
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.4.1.0
Introduced on the E-Series.
Usage
Information
The
remark
command is available in each ACL mode. You can configure up to
4294967290 remarks in a given ACL.
The following example shows the use of the
remark
command twice within
CONFIGURATION-STANDARD-ACCESS-LIST mode. The same sequence number
was used for the remark and for an associated ACL rule. The remark precedes the
rule in the running-config because it is assumed that the remark is for the rule with
the same sequence number, or the group of rules that follow the remark.
Example
Dell(config-std-nacl)#
remark 10 Deny rest of the traffic
Dell(config-std-nacl)#
remark 5 Permit traffic from XYZ Inc.
Dell(config-std-nacl)#show config
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24
remark 10 Deny rest of the traffic
seq 10 Deny any
Dell(config-std-nacl)#
Access Control Lists (ACL)
215
