Defaults
Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.1.1.0
Introduced on the E-Series.
Usage
Information
If you configure the
set next-hop
command, its configuration takes precedence
over the
neighbor next-hop-self
command in the ROUTER BGP mode.
If you configure the
set next-hop
command with the interface’s IP address
(either Loopback or physical), the software declares the route unreachable.
Related
Commands
match ip next-hop
— redistributes routes that match the next-hop IP address.
set origin
To manipulate the BGP ORIGIN attribute, configure a filter.
Z9500
Syntax
set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the
no set origin
command.
Parameters
egp
Enter the keyword
egp
to set routes originating from outside
the local AS.
igp
Enter the keyword
igp
to set routes originating within the
same AS.
incomplete
Enter the keyword
incomplete
to set routes with
incomplete routing information.
328
Access Control Lists (ACL)
