destination
Enter the IP address of the network or host to which the
packets are sent.
operator
(OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports (you must specify two
ports for the
port
command parameter.)
Defaults
none
Command
Modes
REDIRECT-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Added the keyword
track-id
on the Z9500.
9.5(0.1)
Introduced on the Z9500.
9.4(0.0)
Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1
Introduced on the C-Series.
8.4.2.0
Introduced on the E-Series TeraScale.
seq
Configure a filter with an assigned sequence number for the redirect list.
Z9500
Syntax
seq
sequence-number
{permit | redirect {
ip-address | tunnel
tunnel-id}[track <obj-id>]
}} {
ip-protocol-number
|
protocol-
type
} {
source mask
| any | host
ip-address
} {
destination mask
|
any | host
ip-address
} [bit] [
operator
]{source-port
source-
port
| source-port-range
start-port - end-port
} {destination-
port
destination-port
| destination-port-range
start-port - end-
port
}
Policy-based Routing (PBR)
1429
