Prompt
Interface Type
Dell(conf-if-
nu-0)#
Null Interface then zero
Dell(conf-if-
po-0)#
Port-channel interface number
Dell(conf-if-
vl-0)#
VLAN Interface then VLAN number (range 1–4094)
Dell(conf-if-
ma-0/0)#
Management Ethernet interface then slot/port information
Dell(conf-if-
tu-0)#
Tunnel interface then tunnel ID.
Dell(conf-if-
range)#
Designated interface range (used for bulk configuration).
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use
the
ip access-list standard
or
ip access-list extended
command.
To enter IP ACCESS LIST mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Use the
ip access-list standard
or
ip access-list extended
command. Include a name
for the ACL. The prompt changes to include (conf-std-nacl) or (conf-ext-nacl).
You can return to CONFIGURATION mode by using the
exit
command.
ISIS ADDRESS-FAMILY Mode
To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, refer to
Intermediate System to Intermediate System (IS-IS)
.
To enter ISIS ADDRESS-FAMILY mode:
1.
Verify that you are logged in to ROUTER ISIS mode.
2.
Enter the command
address-family ipv6 unicast
. The prompt changes to include (conf-
router_isis-af_ipv6).
LLDP Mode
To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information,
refer to
Link Layer Discovery Protocol (LLDP)
.
To enter LLDP mode:
1.
To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP
on an interface, verify that you are logged in to INTERFACE mode.
2.
Enter the
protocol lldp
command. The prompt changes to include (conf-lldp) or (conf-if-
interface
-lldp).
CLI Basics
55
