Autodesk 24000-000000-9860 - Revit Architecture - PC, Руководство пользователя

Страница: 725 / 1646

5 Specify a base for each post.
6 Optionally, enter a value for Base offset for each.
7 Specify a top for each.
8 Optionally, enter a value for Top offset.
9 Optionally, enter a value for Space.
10 Optionally, enter a value for Offset.
11 Select the location of corner posts, as follows:
Then… If you…
select Each Segment End. want to place a corner post at
the end of each segment of the
railing
select Angles Greater Than, and enter a value for Angle. If the railing turns
at an angle that is greater than this value, a post is placed at the turn. Typic- want to place a corner post
when a railing segment makes
ally, this value remains at 0. Turn angles are measured in the plan view.
Segment breaks in the railing that do not occur at a turn are ignored. a turn greater than a given
value
select Never. do not want to place a post
regardless of any separations
or turns in the railing
12 Click OK.
Post Properties
Following are the display properties for posts.
Description Property
The post family. Alternately, you can select None or Default. Baluster Family
Specifies where the bottom of the post is placed: at the top of the rail, bottom of the rail, or top
of the host. A host can be a level, floor, stair, or ramp. Base
The negative or positive vertical distance between the bottom of the post and the base. Base offset
Specifies where the top of the post is placed (usually a rail). Values are the same as Base. Top
Controlling Placement of Balusters and Posts | 687