604
Troubleshooting
Error
M
essages
22
Error Messages (continued)
Message
Meaning
Handling method
An error occurred while connecting to
the i-mode center.
Move to a location inside the i-mode
service area with good signal
conditions and execute again. If the
message appears again, wait for a while
and try again.
connection interrupted
The connection Host does not support
i-mode.
Set the correct connection Host or
return to the connection host set by
default (see p.302).
connection is not valid
−
Turn the power off and then turn the
power on after waiting for a while. If the
message does not disappear, contact
NTT DoCoMo service center.
check connection
The upper limit of the timeout has been
exceeded.
Try again after moving to a location
inside the i-mode service area with
good signal conditions. If the message
appears again, wait for a while and try
again.
time out
Cannot make a reservation because
the date out of the range from January
1, 2004 to December 31, 2023 is
included as a candidate.
−
invalid date, unable to
reserve
Right after the end of a call (for approx. 5
seconds) or when an additional number
in the Number Plus Service is receiving
an incoming call during the Drive Mode,
Self Mode cannot be set.
Wait for a while and try again.
self mode setting failed
Characters that cannot be sent are
included in the set Paging mode.
Check the Paging mode (see p.58) or
delete the characters that cannot be
sent, and send again.
unable to send 2-byte
letter
When Mail Optional Reception is turned
on, mail is delivered to the i-mode center.
Check the title and sender, and
receive or delete the mail (see p.337).
left in center
An error occurred while receiving mail
or Messages.
Move to a location inside the i-mode
service area with good signal conditions
and perform Check New Message. If the
message appears again, wait for a while
and try again (see p.311, 338).
The application is terminated because
action other than the permitted function
was attempted. The Security error log
is recorded in the mova (see p.425).
If this occurs in the i-
α
ppli Standby
screen, the i-
α
ppli Standby screen
setting is also canceled.
−
software terminated due
to security error
i-
α
ppli stand-by
terminated due to security
error
The partner of infrared communication
was not found.
Make sure that the infrared ports are
within 20 cm of each other and
properly aligned, and execute again.
no response
Execute again ensuring that the angle
and distance of the infrared ports are
not displaced. If the message appears
repeatedly, it is not possible to
communicate with that device.
unable to access by
infrared
unable to exchange by
infrared
An error occurred during infrared
communication.
connection interrupted
by infrared
An error occurred during infrared
communication. There may be a
problem with the communication
partner device.
Execute again ensuring that the angle
and distance of the infrared ports are
not displaced. If the message appears
repeatedly, it is not possible to
communicate with that device.
Summary of Contents for D506i
