SPANNING TREE Mode
To enable and configure the Spanning Tree protocol, use SPANNING TREE mode. For more information,
refer to
.
To enter SPANNING TREE mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the
protocol spanning-tree
stp-id
command. The prompt changes to include (conf-stp).
You can return to CONFIGURATION mode by using the
exit
command.
TRACE-LIST Mode
To configure a Trace list, use TRACE-LIST mode.
To enter TRACE-LIST mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the
ip trace-list
command. Include the name of the Trace list. The prompt changes to
include (conf-trace-acl).
You can exit this mode by using the
exit
command.
VLT DOMAIN Mode
To enable and configure the VLT domain protocol, use VLT DOMAIN mode. For more information, refer
to
To enter VLT DOMAIN mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the
vlt domain
command then the VLT domain number. The prompt changes to include
(conf-vlt-domain).
You can return to CONFIGURATION mode by entering the
exit
command.
VRRP Mode
To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more
information, refer to
Virtual Router Redundancy Protocol (VRRP)
To enter VRRP mode:
1.
To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
2.
Enter the
vrrp-group
command then enter the VRRP group ID. The prompt changes to include
(conf-if-
interface-type
-
slot/port
-vrid-
vrrp-group-id
).
CLI Basics
53
Summary of Contents for Networking S6000 System
