Dell Networking S6000 System, Reference Manual

Page: 186 / 1510

byte (OPTIONAL) Enter the keyword
byte
to count bytes that the
filter processes.
log (OPTIONAL, E-Series only) Enter the keyword
log
to enter
ACL matches in the log.
dscp (OPTIONAL) Enter the keyword
dcsp
to match to the IP
DCSCP values.
order (OPTIONAL) Enter the keyword
order
to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword
order
, the ACLs have the lowest order by default
(255).
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the “Flow-based
Monitoring” section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide .
fragments Enter the keyword
fragments
to use ACLs to control packet
fragments.
Defaults Not configured.
Command
Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Add the DSCP value for ACL matching.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added support for the noncontiguous mask and added the
monitor
option.
186
Access Control Lists (ACL)