54
Virtual Routing and Forwarding (VRF)
Virtual Routing and Forwarding (VRF) allows multiple instances of a routing table to co-exist on the same
router at the same time. Virtual Routing and Forwarding (VRF) is supported on the S-Series platforms.
ip unknown-unicast
Enable IPv4 catch-all route.
S6000
Syntax
ip unknown-unicast [vrf
vrf-name
]
To remove the IPv4 catch-all route (0.0.0.0/0) from the LPM route forwarding
table in hardware which gets added as a default configuration after the initialization
of FIB Agent module, use the
no ip unknown-unicast
command.
Defaults
None
Parameters
vrf
vrf-name
(Optional) Enter the keyword
vrf
followed by the name of
the VRF to enable catch-all routes corresponding to that
VRF.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0)
Introduced on the S–Series.
Usage
Information
Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route
forwarding table if it was deleted using the
no ip unknown-unicast
command
previously. This will be the default configuration after reload.
ipv6 unknown-unicast
Disable soft forwarding of unknown IPv6 destination packets.
S6000 MXL Switch
Syntax
[no] ipv6 unknown-unicast
Virtual Routing and Forwarding (VRF)
1447
Summary of Contents for Networking S6000 System
