Dell Networking S6000 System, Reference Manual

Page: 1044 / 1510

Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information Setting the delay and holdtime parameters to a low number enables the switch to
an alternate path quickly but requires more CPU usage.
timers throttle lsa all
Configure LSA transmit intervals.
S6000
Syntax
timers throttle lsa all {start-interval | hold-interval | max-
interval}
To return to the default, use the
no timers throttle lsa
command.
Parameters
start-interval Set the minimum interval between initial sending and
resending the same LSA. The range is from 0 to 600,000
milliseconds.
hold-interval Set the next interval to send the same LSA. This interval is the
time between sending the same LSA after the start-interval
has been attempted. The range is from 1 to 600,000
milliseconds.
max-interval Set the maximum amount of time the system waits before
sending the LSA. The range is from 1 to 600,000
milliseconds.
Defaults
• start-interval: 0 msec
• hold-interval: 5000 msec
• max-interval: 5000 msec
Command
Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 9.0.2.0 Introduced on the S6000..
Version 8.3.11.1 Introduced on the Z9000.
1044
Open Shortest Path First (OSPFv2 and OSPFv3)