Dell Networking S6000 System, Reference Manual

Page: 464 / 1510

dcb-output
To associate an ETS configuration with priority traffic, create a DCB output policy.
S6000
Syntax
dcb-output policy-name
To remove the ETS output policy globally, use the
no dcb output policy-name
command.
Parameters
policy-name Enter the DCB output policy name. The maximum is 32
alphanumeric characters.
Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
To associate a priority group with an ETS output policy with scheduling and
bandwidth configuration, create a DCB output policy. You can apply a DCB output
policy on multiple egress ports. When you apply an ETS output policy on an
interface, ETS-configured scheduling and bandwidth allocation take precedence
over any configured settings in QoS output policies.
The ETS configuration associated with 802.1 priority traffic in a DCB output policy
is used in DCBX negotiation with ETS peers.
Related
Commands dcb-policy output — applies the output policy.
464
Data Center Bridging (DCB)