Dell Networking S6000 System, Reference Manual

Page: 1338 / 1510

Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information The following example configures a community named public that is mapped to
the security named guestuser with Read Only (
ro
) permissions.
The
security-name
parameter maps the community string to an SNMPv3 user/
security name as defined by the community MIB.
If a community string is configured without a
security-name
(for example,
snmp-server community public ro
), the community is mapped to a default
security-name/group:
•
v1v2creadu / v1v2creadg
— maps to a community with
ro
(read-only)
permissions.
•
v1v2cwriteu/ v1v2cwriteg
— maps to a community with
rw
(read-write)
permissions.
The
community-name
parameter indexes this command.
If you do not configure the
snmp-server community
command, you cannot
query SNMP data. Only Standard IPv4 ACL and IPv6 ACL is supported in the
optional
access-list-name
.
The command options
ipv6
,
security-name
, and
access-list-name
are
recursive. In other words, each option can, in turn, accept any of the three options
as a sub-option, and each of those sub-options can accept any of the three sub-
options as a sub-option, and so forth. The second Example shows the creation of a
standard IPv4 ACL called
snmp-ro-acl and then assigning it to the SNMP
community guest .
1338
Simple Network Management Protocol (SNMP) and Syslog