Dell Networking S6000 System, Reference Manual, Page: 1321 / 1510

sflow collector
Configure a collector device to which sFlow datagrams are forwarded.
S6000
Syntax
sflow collector { ip-address | ipv6-address } agent-addr { ip-
address | ipv6-address } [ number [max-datagram-size number ]] |
[max-datagram-size number ] [vrf management]
To delete a configured collector, use the
no sflow collector { ip-address |
ipv6-address } agent-addr { ipv4-address | ipv6-address } [ number
[max-datagram-size number ]] | [max-datagram-size number ] [vrf
management]
command.
Parameters
sflow collector
ip-address |
ipv6-address
Enter the IP address of the collector in dotted decimal
format for IPv4 or x:x:x:x::x format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
agent-addr ip-
address | ipv6-
address
Enter the keyword
agent-addr
followed by the sFlow agent
IP address in dotted decimal format for IPv4 or x:x:x:x::x
format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
number (OPTIONAL) Enter the user datagram protocol (UDP) port
number. The range is from 0 to 65535. The default is 6343.
max-
datagram-size
number
(OPTIONAL) Enter the keyword max-datagram-size then the
size number in bytes. The range is from 400 to 1500. The
default is
1400 .
vrf
management (OPTIONAL) Enter the keyword
vrf
followed by the keyword
management
to configure the collector device
corresponding to the default VRF and the management VRF
respectively.
Defaults Not configured.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0) Added support for VRF.
sFlow
1321