Dell Networking S6000 System, Reference Manual

Page: 81 / 1510

cam-acl
{default | l2acl
number ipv4acl
number ipv6acl
number ,
ipv4qos
number l2qos
number l2pt nu
mber ipmacacl
number
ecfmacl
number [vman-
qos | vman-
dual-qos
number }
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space
to be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Enter
4
or
8
for the number of OpenFlow FP blocks.
•
4
: Creates 242 entries for use by the OpenFlow controller
(256 total entries minus the 14 entries reserved for
internal functionality)
•
8
: Creates 498 entries for use by the OpenFlow controller
(512 total entries minus the 14 entries reserved for
internal functionality)
Enter the CAM profile name followed by the amount to be
allotted. The total space allocated must equal 13. The ipv6acl
range must be a factor of 2.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.2) Added support for the
fcoe
parameter on the S4810 and
S4820T.
Version 9.1.
(0.0) Added support for OpenFlow on the Z9000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Added the keywords
fcoeacl
and
iscsioptacl
on the
S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Added the keywords
ecfmacl
,
vman-qos
, and
vman-dual-
qos
.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-
config (
write-mem
or
copy run start
) then reload the system.
Control and Monitoring
81