Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.4.2.1
Added support for the optional
guard
keyword on the C-
Series, S-Series, and E-Series TeraScale.
Version 8.3.7.0
Introduced on the S4810.
Version 8.2.1.0
Introduced the
hardware shutdown-on-violation
options.
Version 7.6.1.0
Introduced on the S-Series.
Version 7.5.1.0
Introduced on the C-Series.
Version 7.4.1.0
Added the optional bridge port data unit (BPDU) guard.
Version 6.2.1.1
Introduced on the E-Series.
Usage
Information
The
BPDU guard
option prevents the port from participating in an active STP
topology in case a BPDU appears on a port unintentionally, or is misconfigured, or
is subject to a DOS attack. This option places the port into an Error Disable state if a
BPDU appears and a message is logged so that the administrator can take
corrective action.
NOTE: A port configured as an edge port, on an RSTP switch, immediately
transitions to the Forwarding state. Only configure ports connected to end-
hosts as edge ports. Consider an edge port similar to a port with a
spanning-
tree portfast
enabled.
If you do not enable
shutdown-on-violation
, BPDUs are still sent to the RPM
CPU.
You cannot enable STP root guard and loop guard at the same time on a port. For
example, if you configure loop guard on a port on which root guard is already
configured, the following error message displays:
% Error: RootGuard is
configured. Cannot configure LoopGuard
.
Enabling Portfast BPDU guard and loop guard at the same time on a port results in
a port that remains in a Blocking state and prevents traffic from flowing through it.
For example, when Portfast BPDU guard and loop guard are both configured:
• If a BPDU is received from a remote device, BPDU guard places the port in an
Err-Disabled Blocking state and no traffic is forwarded on the port.
Rapid Spanning Tree Protocol (RSTP)
1217
Summary of Contents for Networking S6000 System
