Usage
Information
You can only configure one domain name with the
ip domain-name
command.
To configure more than one domain name, configure the
ip domain-list
command up to six times.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the
ip name-server
command
• enable DNS with the
ip domain-lookup
command
To view current bindings, use the
show hosts
command.
Related
Commands
— configures additional names.
ip helper-address
Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the
DHCP server is not on the same subnet as the client.
S6000
Syntax
ip helper-address
ip-address
To remove a DHCP server address, use the
no ip helper-address
command.
Parameters
ip-address
Enter an IP address in dotted decimal format (A.B.C.D).
Defaults
Not configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version 9.0.0.0
Added support for IPv6.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 8.1.1.0
Introduced on the E-Series ExaScale.
Version 7.9.1.0
Introduced VRF on the E-Series.
IPv4 Routing
725
Summary of Contents for Networking S6000 System
